190 E – PENETRO GREEN – H1

190E PENETRO® GREEN H1

190E Penetro Green H1 is a high performance, extreme pressure, anti-wear food grade penetrating oil that penetrates and lubricates all types of moving parts and chain applications that require a USDA H-1 type oil where incidental contact with food may occur.

190E Penetro Green H1 is blended from the finest quality, highly refined and purified non-toxic, non-staining technical white, U.S.P. grade oils and synthetic isoparaffinic hydrocarbons available. Combined with these food grade white oils and isoparaffinic hydrocarbons is a very specialized non-toxic food grade approved friction releasing additive package. These friction releasing additives deposit a long lasting solid lubricant film that not only greatly reduces friction and wear, but also when used on chains provides extreme pressure an anti-wear protection that can triple the life of the chains and sprockets.

190E Penetro Green H1 once applied to the surface of the mechanism will clean and provide that mechanism with a protective shield that rejects abrasive particles such as dirt and salt. This protective shield will also protect against moisture and inhibit the formation of rust and other corrosive buildup that damages working mechanisms.

190E Penetro Green H1 can be used to lubricate the following mechanisms on food processing plants,
where incidental contact with food may occur:

Valves
Linkages
Conveyors
Chains
Trolley Hooks
Rollers
Cutting Tools

Directions For Use:

1. Shake well before use.
2. When applying to heavily corroded parts, first scrape or wire brush. Allow a short time to penetrate.
3. Wipe away accumulated grit and grime that may appear as parts operate.

Specific Gravity
0.8861
ISO Grade
15
Viscosity, Sus @ 40°C (ASTM D-445)
75.4-81.4
Viscosity, Cst @ 40° C (ASTM D-445)
14.5-16
Flash Point °F/°C (ASTM D-92)
239°/115°
Rust Test (ASTM D-665)
Procedure A (Distilled Water)
Pass
Procedure B (Salt Water)
Pass
Four Ball Wear Test (ASTM D-4172)
(40kg, 1200 RPM, 1hr @ 167°F)
Scar Diameter, mm
0.84
Four Ball EP Test (ASTM D-2783)
Weld Point, kg
Load Wear Index, Kg
56.77
Timken EP Test (ASTM D-2782)
Ok Load, lb
65
Fail Load, lb
70
Dielectric Strength (ASTM D-877)
35 KV